Our mid-range industrial line up consists of three machines. All three utilize the same basic frame, but offer different drive systems and controllers to suite different budgets and functional requirements.

SeriesOne Classic: The SeriesOne Classic is our orriginal entry level machine. With over 600 of these machines in the field, the SeriesOne Classic has proven itself to be low maintanance industrial workhorse. It features a roller chain final drive connected to hybrid step motors through timing belts. The classic gantry is diven from both sides via a drive shaft using a single motor. The Controller is a new Dell PC running Windows 10 and Mach3 software.

XT: The SeriesOne XT offers an upgrade from belt driven roller chain drive to a rack and pinion drive with planetary gear boxes. The XT also uses two motors to drive the gantry (one on each side) rather that a single motor with a drive shaft. The XT drive system offers a little more rigidity in the system over roller chain, which can be beneficial when cutting intiquate designs (artwork) at higher speeds. Acceleration and cut speeds can typically be run higher than on the SeriesOne.  The XT also includes a new Dell PC running Windows 10 and Mach3 software.

XT-Performance: The SeriesOne Performance takes the XT to the next level by eliminating the PC and Mach3 control software. The Performance uses the Victor iCNC Performance control with the Victor iHC lifter and height control. The Performance control, unlike Mach3, was designed and purpose built for plasma cutting. It offers user freindly features not available in Mach3 and because the control was built from the board level for plasma cutting and it is capable of running high definition plasma. This model also includes ProMotion Nest software for your desktop. A servo upgrade is available for the XT-Performance.

       
  SeriesOne XT XT Performance
Controls PC/Mach3 PC/Mach3 Victor iCNC Performance
Lifter NEMA 23 W/Lead Screw NEMA 23 W/Lead Screw Victor iHC Lifter
X&Y Drive NEMA 34 stepper NEMA 34 stepper NEMA 34 stepper
X&Y Primary Reduction Timing Belt Planetary Gear Drive Planetary Gear Drive
X&Y Final Drive Roller Chain Rack & Pinion Rack & Pinion
Rail Type V-Roller V-Roller V-Roller
Gantry Drive Config Dual Side, Single Motor Dual Side, Dual Motor Dual Side, Dual Motor
Nesting Software SheetCAM SheetCAM Promotion Nest
Plasma Compatability Air Plasma Only Air Plasma Only Air and High Defition
       
Base model Pricing. Includes choice or water table or open grid system.
4 X 8 $9,995 $12,995 $24,995
5 X 10 $11,995 $14,995 $26,995
6 X 12 $14,995 $17,995 $28,995

 


RC Enterprises * 208 Edwards Drive * Jackson * TN * 38301 * (615) 290-6260