Our pricing structure is very straightforward. Prices shown do not reflect any discounts, dealer incentives, etc. Use this guide to get a fairly accurate machine cost estimate. Note that due to the size of a typical cutting bed, that component is typically built by the customer on-site to our plans. A typical pneumatic water table with an 8' x 16' cutting area can be build for between $3000 and $3500 in materials. If you would rather not build the cutting bed, please contact us for pricing.

All machines include the Victor iCNC XT control with automatic height control. The control is available with or without DiameterPro software and nesting.

Select Your Gantry Width

 




Widths are measured from inside to inside. A typical 8x16 machine with 1 plasma and 1 oxy torch would use a 10' gantry. The 16' gantry offers more cutting area and/or more parking space for accessory stations.

   
Select Long Axis Rail Length

Long (Y) axis rail lengths are available in increments of 20'. Cutting area will be about 48" less than the total selected rail length.

For lengths greater than 80', please call.

 
Select Control No control
Victor XT (Control Only)
Victor XT (W/Diameter Pro and Nesting)
 
   
Select a Plasma Power Supply




(Auto Gas)
(Auto Gas)
(Auto Gas)
(Auto Gas)
(Manual Gas)
(Manual Gas)
(Manual Gas)
(Manual Gas)

   
Approximate Lead Length Required



Lead lengths depend largely on placement of the plasma power supply relative to the table. 50' leads are the most common. For lead lengths greater than 75', Please Call.
   
Select Options


Oxy/Fuel (Station 1)
Oxy/Fuel (Station 2)
Oxy/Fuel (Station 3)
Oxy/Fuel (Station 4)

 

   
Setup, Training and Delivery On-Site Setup, Training & Delivery  
   
TN State Sales Tax, 9.75% About TN Sales Tax
   
Sub Total  
Sales Tax  
Total Apply for financing today!

 

 


RC Enterprises * 208 Edwards Drive * Jackson * TN * 38301 * (615) 290-6260